home
application
LEDs
Photodiodes
Laser Diodes
about us
ELECTRONIC DEVICES
Drivers for LED
on TO-18 package
D-21; D-31;
D-21 GENERAL
D-21 Instructions
D-31 GENERAL
D-31 Instructions
Driver and temperature controller for LED
on TO-5 package
with build-in thermocooler
DLT-27; DLT-37;
DLT-27
DLT-37
Amplifier & Temperature Controller for PDs
AM-07; AMT-07;
AM-07
for PD on TO-18
AMT-07
for PD on TO-5
| PD Amplifier & Temperature Controller Model AMT-07 | |||||||||||||||
| ž Amplifier AMT-07 converts the current output of a signal source such as for example Mid-Infrared photodiode, into a voltage output with amplification of the voltage for subsequent use with various electronic systems, like lock-in-amplifiers, oscilloscopes or A/D converters. In the same package is included also Sinchrodetector that gives direct current proportional to the signal at selected frequency. Customer can see the signal on LC Display. ž Amplifier AMT-07 is designed for operation with photodiodes with built-in termocooler and thermistor (Models PDXX-XX-TEC). Customer can select and set the temperature of PD operation. Circuit with feedback will set the necessary thermocooler current for maintaning the selected temperature. |
 | ||||||||||||||
| |||||||||||||||
 |
LC Display can be switched to work in one of three possible modes: 1) LC Display shows amplified signal after synchrodetecting. 2) LC Display shows installed temperature 3) LC Display shows real measured temperature on photodiode chip |
||||||||||||||